By Mark J. Donovan
Yesterday I spent much of the day opening our pool for the summer. As usual I was filled with in trepidation as I began pulling back the cover. Opening the pool never goes smoothly.
There is first the process of removing the cover. Inevitably it is filled with water with decaying leaves. No matter how much you skim the cover first, you still wind up dumping dirty water and other organic matter into your pristine pool water that sits below the cover.
Next comes the installation of the water filter and its associated chemical delivery contraptions. There are a myriad of hoses that connect to these pieces and to the pool itself. Without fail, there is always something on this hulk of plastic and hoses that either breaks when you tighten it or springs a leak when you turn the pump on. To lower the risk of leaks, I normally buy a new set of hoses annually. However something else usually breaks. I am convinced pool manufacturers use the lowest quality plastics possible. One season in the sun and they become brittle and crack. Its as if the pieces are human, and burn like our skin.
Once the filter and hoses are hooked up its then time to remove the rubber seal that is covering the drain trap. This can be a challenge. Sometimes you drop a screw into the pool or you wind up loosing 100 gallons of water in the process. I’ve learned over the years to remove just two or 3 screws at a time when removing this rubber seal. You minimize water loss and you have fewer screws to fumble around with in your hands.
After removing the rubber seal on the drain trap, all that’s left to enable you to turn on the motor is to remove the plug on the output vent. This usually takes a towel and a little praying and cajoling to get it off.
With all the hardware connected it’s now time to start the chemicals. Again, I like to plan ahead and get them well in advance. Unfortunately, I always still find myself short of some chemical or a PH tester, or in this year’s case water. Yes, there was water high enough in the pool that it flowed into the drain, however this year it was apparently insufficient, or so I initially thought. The jet pressure was low and I could not seem to build it up. After multiple tries I finally discovered that as usual, there was a crack/leak in the system. This year it was the 2-year-old chlorine delivery contraption. There were multiple pinhole leaks that sprayed out a fine mist of water when the motor was running.
So today I am off finding a new chlorine filter. With a little luck, by this evening my pool will be operational and I will be reflecting whether or not it’s all worth it. Right now my opinion is, its not. However when the hot, sultry days of August hit, I’ll probably be changing my tune once again.
Opening the Pool
When thinking a Green Home Consider an Earth Home
By Mark J. Donovan
When thinking about going green with your next home purchase or custom home building project, consider an Earth Home.
An Earth home is extremely energy efficient. It is typically covered by three sides, and its roof, with several feet of soil, rock and/or concrete. It typically has one open side that faces the south or southwest for maximum passive solar heating benefit.
One of the major reasons an earth home is extremely energy efficient is that it is encased in the earth which has typically has a constant temperature of around 55 degrees farenheight. In addition, when building an earth home, the home is typically encased with rigid insulation and waterproofing on the outside concrete walls before they are backfilled with soil/earth.
Another reason earth homes are so environmentally friendly is that they are typically small in square footage. In addition, they usually have few windows, except for the open side. Consequently their heating/air conditioning requirements are minimal.
Though the lack of square footage and windows could initially be considered a turn off by many, with proper architectural considerations, such as creating large open areas and using interior lighting intelligently, an earth home can be designed to feel large and bright. In addition, the open side, facing south can be designed as a wall of windows to maximize solar heat and sunlight.
Another major cost savings with earth homes is the low cost of home insurance. Earth homes are less susceptible to wind damage, hail damage, theft and fire.
So if you are thinking of building a green home, research the idea of an Earth Home. You may be surprised on how roomy and contemporary an earth home can be.
Key Electrical Tools when tackling minor Home Wiring Projects
Mark Donovan of HomeAdditionPlus.com reviews the basic Home Wiring tools necessary for tackling a small wiring project around the home.
Tools mentioned in the video include a unique wire stripper, a multimeter, screwdrivers, pliers and a couple of other interesting tools.